![]() ![]() For a replacement or refund please contact customer service at 1-80. ![]() ![]() If this product, when applied and maintained according to product application and maintenance instructions to a properly prepared surface, fails to perform to your complete satisfaction, Minwax shall, upon presentation of proof of purchase, either replace an equivalent quantity of product free of charge or refund the original purchase price. This warranty is not transferable except that if a contractor purchased and applied the product to the property for you, then the warranty is transferable to you. This warranty is made to you, the product purchaser who owns the property where the product is applied. Let dry between fillings.Sand filler smooth and flush to the wood.​Remove all sanding residue before staining, top coating, or painting.STAINING & FINISHING:Touch up with Minwax Markers or choose a Minwax penetrating stain, such as Minwax Wood Finish, Minwax Water-Based Stain or Minwax Gel Stain.Apply according to label directions.After staining, apply a protective clear finish for long lasting beauty and protection.For exterior use apply Minwax Helmsman Spar Urethane. Most common shallow repairs will dry within 45 minutesDeeper repairs may need more than one filling and may require 2-6 hours to dry. Dry time will vary depending on depth of area to be filled. Using a putty knife, spread a liberal amount of Wood Filler into the area to be filledPress the filler firmly in placeFill slightly above surface while minimizing overspreading on surrounding areas.FOR WIPING:No sanding requiredScrape off access wood filler with the putty edge.After approximately 5 minutes, WIPE the area around it with a clean, damp rag while the filler is still wet.FOR SANDING:Allow the filler to dry completely. ![]()
0 Comments
Leave a Reply. |